Use this command to enable individual OSPF traps, enable a group of trap flags at a time, or enable all the trap flags at a time. The
different groups of trapflags, and each group's specific trapflags to enable or disable, are listed in Table 1.
Table 1. Trapflag Groups (OSPFv3)
| Group |
Flags |
|
errors
|
-
authentication-failure
-
bad-packet
-
config-error
-
virt-authentication-failure
-
virt-bad-packet
-
virt-config-error
|
|
lsa
|
|
|
overflow
|
-
lsdb-overflow
-
lsdb-approaching-overflow
|
|
retransmit
|
|
|
state-change
|
-
if-state-change
-
neighbor-state-change
-
virtif-state-change
-
virtneighbor-state-change
|
- To enable the individual flag, enter the group name followed by that particular flag.
- To enable all the flags in that group, give the group name followed by all.
- To enable all the flags, give the command as trapflags all.
|
Default
|
Disabled
|
|
Format
|
trapflags {all |errors {all | authentication-failure | bad-packet | config-error | virt- authentication-failure |
virt-bad-packet | virt-config-error} | lsa {all | lsa-maxage | lsa-originate} | overflow {all | lsdb-overflow |
lsdb-approaching-overflow} | retransmit {all | packets | virt-packets} | state-change {all | if-state-change |
neighbor-state-change | virtif-state-change | virtneighbor-state-change}}
|
|
Mode
|
Router OSPFv3 Config
|
