Use this command to display the DHCP Snooping binding entries. To restrict the output, use the following options:
- Dynamic: Restrict the output based on DCHP snooping.
- Interface: Restrict the output based on a specific interface.
- Static: Restrict the output based on static entries.
- VLAN: Restrict the output based on VLAN.
| Format | show ipv6 dhcp snooping binding [{static/dynamic}] [interface unit/slot/port] [vlan id] |
| Mode |
|
| Term | Definition |
|---|---|
| MAC Address | Displays the MAC address for the binding that was added. The MAC address is the key to the binding database. |
| IPv6 Address | Displays the valid IPv6 address for the binding rule. |
| VLAN | The VLAN for the binding rule. |
| Interface | The interface to add a binding into the DHCP snooping interface. |
| Type | Binding type; statically configured from the CLI or dynamically learned. |
| Lease (sec) | The remaining lease time for the entry. |
Example: The following shows example CLI display output for the command.
(switch) #show ipv6 dhcp snooping binding Total number of bindings: 2 MAC Address IPv6 Address VLAN Interface Type Lease time (Secs) ------------------ -------------- ---- --------- ---- ------------------ 00:02:B3:06:60:80 2000::1/64 10 0/1 86400 00:0F:FE:00:13:04 3000::1/64 10 0/1 86400
