Use this command to display the Dynamic ARP Inspection configuration on all the DAI-enabled interfaces. An interface is said to be enabled for DAI if at least one VLAN, that the interface is a member of, is enabled for DAI. Given a unit/slot/port interface argument, the command displays the values for that interface whether the interface is enabled for DAI or not.
| Format | show ip arp inspection interfaces [unit/slot/port] |
| Mode |
|
| Term | Definition |
|---|---|
| Interface | The interface ID for each displayed row. |
| Trust State | Whether the interface is trusted or untrusted for DAI. |
| Rate Limit | The configured rate limit value in packets per second. |
| Burst Interval | The configured burst interval value in seconds. |
Example: The following shows example CLI display output for the command.
(switch) #show ip arp inspection interfaces
Interface Trust State Rate Limit Burst Interval
(pps) (seconds)
--------------- ----------- ---------- ---------------
0/1 Untrusted 15 1
0/2 Untrusted 10 10
