Use this command to display the IEEE 802.3 Annex 31B flow control settings and status for a specific interface or all interfaces. The command also displays 802.3 Tx and Rx pause counts. Priority Flow Control frames counts are not displayed. If the port is enabled for priority flow control, operational flow control status is displayed as Inactive.
Operational flow control status for stacking ports is always displayed as N/A.
| Format | show flowcontrol [unit/slot/port] |
| Mode | Privileged EXEC |
Example: The following shows example CLI display output for the command.
(Switching)#show flowcontrol
Admin Flow Control: Symmetric
Port Flow Control RxPause TxPause
Oper
------ ------------ -------- ---------
0/1 Active 310 611
0/2 Inactive 0 0
Example: The following shows example CLI display output for the command.
(Switching)#show flowcontrol interface 0/1
Admin Flow Control: Symmetric
Port Flow Control RxPause TxPause
Oper
------ ------------ -------- ---------
0/1 Active 310 611
